Pub Table Sets And Modern Furniture

6 Responses to “my stools are too high for the pub table how can i fix it?”

1. jas Says:
   January 20th, 2010 at 12:30 pm

   cut the legs or get new ones
   if u cut then measure very carefully
   References :

2. Bobs MonOncle Says:
   January 20th, 2010 at 1:11 pm

   I regularly cut a bit off stools to adjust them down for customers. As long as there is a non-detailed foot, this is not hard to do.
   References :

3. Hex92 Says:
   January 20th, 2010 at 1:57 pm

   Gosh that is a hard one. You say the stools are too tall for the table….hmmmm I guess what I would do is cut a hole in the floor so you can lower their height.

   Or maybe you could hang the table from the ceiling to make it taller.

   There might be something more obvious that you could do, but I just can’t think of what it could be.
   References :

4. SIMEON S Says:
   January 20th, 2010 at 2:44 pm

   Get a sharp hand saw. Put a layer of masking tape around each leg approximately where you want to cut. With ruler or tape measure, mark each leg 3 or 4 sides the intended cut height. Connect the marks making a circle around the leg.
   Repeat for all legs. Repeat for all stools. Cut should be parallel to floor, not a perfect circle. Take stools outside. Cut one stool. Bring first stool inside and check. Small height difference can be adjusted with course sandpaper.
   Or add wood to table to increase height.
   References :

5. hardhoustonprofessional Says:
   January 20th, 2010 at 2:53 pm

   It will be easier to raise the base on the table than cut off the bar stools. Sometimes common sense escapes all of us…tooshay!
   References :

6. Alyssa J Says:
   January 20th, 2010 at 3:10 pm

   yes, cut them if you can. and if you cant get them all even get the adjustable leg caps from a hardware store that you can srew in or out to make tiny adjustments.

   if the stools cant be cut then i guess you could build a little platform for the table to sit on
   References :

Leave a Reply